How to Replace FROG Mineral Cartridges Not required with salt system
The POOL FROG® mineral reservoir must be replaced every 6 months or after one pool season whichever is shorter.
1 Turn off the pump.
2 Put the ball valve in the “closed position”
3 Open air release valve on top of filter.
4 Set Frog Dial to 0 (Pack Removal)
5 Unscrew and remove the top of FROG Cycler canister.
6 Remove Bac Pac and Mineral Reservoir.
7 Replace with new FROG ® Mineral Reservoir. Be sure to line up
the slot in the reservoir with the fin inside of the canister as shown
8 Lower Bac Pac into Mineral Reservoir until secure. Be sure to line
up the small leg of the Bac Pac with the small opening in the
Mineral Reservoir and the large leg with the large opening
9 Replace cap by hand only. DO NOT OVER TIGHTEN
DO NOT USE CAP TOOL TO TIGHTEN
CAP. Use for removal only.
10 Set Frog Dial back to normal operating level.
11 Put the ball valve in the “open position”
12 Start pump to purge air from the system.
13 When steady stream of water comes from air release valve close the valve.