How to Replace Not required with salt system
FROG Bac Pac
The FROG® Bac Pac must be replaced every 2-3 weeks depending on use
1 Turn off the pump.
2 Put the ball valve in the “closed position”
3 Open air release valve on top of filter.
4 Set Frog Dial to 0 (Pack Removal)
5 Unscrew and remove the top of FROG Cycler canister.
6 Remove Bac Pac.
7 Remove Bac Pac colored caps, grab on to the lip of one cap with a
pliers and pull up until cap releases. Repeat the process for the
WARNING Avoid sparks, open flame or smoking when handling the Bac Pac
8 Turn Bac Pac over and shake slightly until chlorine tablets fall into tower areas.
9 Line up the small leg of the Bac
Pac with the small opening in
the Mineral Reservoir and the
large leg with the large opening.
• Lower Bac Pac into Mineral Reservoir until secure.
10 Replace cap by hand only. DO NOT OVER TIGHTEN
DO NOT USE CAP TOOL TO TIGHTEN
CAP. Use for removal only.
11 Set Frog Dial back to normal operating level
12 Put the ball valve in the “open position”
13 Start pump to purge air from the system.
14 When steady stream of water comes from air release valve close the valve.